Pre orders are open!
In the design process for a new bar we realised that cutting a carbon tube in the center to accomodate a hole through the center and trying to reinforce it back to it’s origial strength and stiffness will always come at a cost of added weight. Inspired by the bars from the early years of our sport we designed a slimmed down screw on hole for the depower cord adding only 12gr to the bar while being more ergonomic than would expect!
For the bar ends we fully embraced to modern proffessional 3d-printing capabilities to design a lightweight functional bar end with integrated bungees and a a shape that is easy to wind the lines on and stores even the longest lines sets with ease.
– Bar ends come in two options: a light version with a wide range of colors, SLS printed and dyed PA12 and a 3gr heavier version that is infused with glass beads for extra strength and stiffness. MJF printed from PA12
– Any width is possible, the new production process allows us to cut the tubes to any length and without the need to stock specific sizes. Availability is limited by the producer of the carbon tubes.
– Diameter of the bar is very personal and this is why we took this into account designing our new bar. It comes now in 20mm, 22mm and 25mm (like the max bar v2) The 22mm comes in a lightweight version and a heavier stiff version for those that want a small diameter bar and prefer the extra stiffness over weight. All the V3 bars will be lighter compared to our previous bar.
50cm 20mm bar – 83grams – 20x18mm tube, lightweight
50cm 22mm bar – 87grams – 22x20mm tube, lightweight
50cm 22mm bar – 126grams – 22x18mm tube, extra stiff
50cm 25mm bar – 104grams – 25×22.5mm tube, best stiffness/weight ratio